Higher Education and Research Bill — New Clause 2 — Student Loans — Restrictions on Modification of Repayment Terms — 21 Nov 2016 at 19:00

Anna Soubry MP, Broxtowe voted not to restrict modifications to student loan terms by only allowing such changes with the approval of an independent panel and where the changes protect those on low income and are favourable to the majority of students and graduates.

MPs were considering the Higher Education and Research Bill[1]

The majority of MPs voted not to restrict modifications to student loan terms, once the loan is in place, by only allowing such changes with the approval of an independent panel and where the changes protect those on low income and are favourable to the majority of students and graduates.

The proposed new clause rejected in this vote was titled Student support: restricted modification of repayment terms and stated:

  • “(1) Section 22 of the Teaching and Higher Education Act 1998 (power to give financial support to students) is amended in accordance with subsections (2) to (4).
  • (2) In subsection (2)(g) at the beginning insert ‘Subject to subsections (3)(A) and (3)(B),’.
  • (3) In subsection (2)(g) leave out from ‘section’ to the end of subsection (2)(g).
  • (4) After subsection (3) insert—
  • ‘(3A) Other than in accordance with subsection (3B), no provision may be made under subsection (2)(g) relating to the repayment of a loan that has been made available under this section once the parties to that loan (including the borrower) have agreed the terms and conditions of repayment, including during—
  • (a) the period of enrolment on a course specified under subsection (1)(a) or (1)(b), and
  • (b) the period of repayment.
  • (3B) Any modification to any requirement or other provision relating to the repayment of a loan made available under this section and during the periods specified in subsection (3A) shall only be made if approved by an independent panel.
  • (3C) The independent panel shall approve modifications under subsection
  • (3B) if such modifications meet conditions to be determined by the panel.
  • (3D) The approval conditions under subsection (3C) must include that—
  • (a) the modification is subject to consultation with representatives of the borrowers,
  • (b) the majority of the representative group consider the modification to be favourable to the majority of students and graduates who have entered loans, and
  • (c) there is evidence that those on low incomes will be protected.
  • (3E) The independent panel shall consist of three people appointed by the Secretary of State, who (between them) must have experience of—
  • (a) consumer protection,
  • (b) loan modification and mediation,
  • (c) the higher education sector, and
  • (d) student finance.’”

==

Debate in Parliament |

Party Summary

Votes by party, red entries are votes against the majority for that party.

What is Tell? '+1 tell' means that in addition one member of that party was a teller for that division lobby.

What are Boths? An MP can vote both aye and no in the same division. The boths page explains this.

What is Turnout? This is measured against the total membership of the party at the time of the vote.

PartyMajority (No)Minority (Aye)BothTurnout
Con277 (+2 tell) 0085.1%
DUP0 4050.0%
Green0 10100.0%
Independent0 1033.3%
Lab0 166 (+2 tell)072.4%
LDem0 6075.0%
SDLP0 2066.7%
UKIP1 00100.0%
Total:278 180079.1%

Rebel Voters - sorted by party

MPs for which their vote in this division differed from the majority vote of their party. You can see all votes in this division, or every eligible MP who could have voted in this division

Sort by: Name | Constituency | Party | Vote

NameConstituencyPartyVote
no rebellions

About the Project

The Public Whip is a not-for-profit, open source website created in 2003 by Francis Irving and Julian Todd and now run by Bairwell Ltd.

There are lots of plans afoot, including extensive redevelopment of the site and plans for new functionality. To keep up with what's happening, please check out the blog. We're working on updating all the contact details throughout the site, but if you'd like to talk to us about the project, please email [email protected]

The Whip on the Web

Advertisement - Helping keeping PublicWhip alive